BowlingFans.com, The site for the fans, by the fans....






ballbeat - get the scoop on pro drillings




      BallBeat gives fans access to exactly which bowling balls the pros were throwing and how the equipment was drilled and prepared for the telecasts.
      Ball manufacturer representatives and pro bowlers: click here.

-Tournament of Champions

  • Brunswick - Rick Benoit wrote:
          Brunswick had 2 representatives on the show at the Tournament of Champions, Walter Ray Williams Jr. and Steve Jaros.

    Steve was using a Contact Zone with a 4 1/4 inch pin with the CG kicked out and an extra hole 5 inches over and 3 inches down. The surface was out of the box.

    Walter was using a Danger Zone HPC with a 4 1/2 inch pin the CG was on the midline directly beneath the pin. There was an extra hole 1 1/2 inches past his axis point on the midline. The surface was prepared with Trizact to 35 microns.

  • Columbia 300 - Chad Murphy wrote:
          Dave Husted used our new ball The "ROCK STAR." The pin was around three and a half inches from his axis. The cg a little closer with a medium sized extra hole. Dave bowled well all week. As you could tell scores were pretty low and circumstances were very tough. Congrats to everyone who made the show as it really was a "grind out" condition. We'll c-ya next week at the Columbia 300 open in Austin.

  • Storm - Hank Boomershine wrote:
          Tommy Delutz, Jr was throwing Elixir's, on the show. On the left lane he was throwing a 5 3/4 in. pin with the cg 4 1/2 with an extra hole, and on the right lane he was throwing a 6 in. pin with the cg 5 1/2 from his axis. Both balls were out of the box. The left lane was slightly tighter than the right so he used the ball with the hole to get it to start up. It was a tough shot that night and all week.


Recent BowlingFans.com BallBeat Updates

-PBA Miller High Life Open
    Pat Healey Jr
-PWBA Columbia 300 Open
    Wendy Macpherson
-PBA Greater Nashville Open
    Tim Criss




A NOTE TO BALL MANUFACTURER REPRESENTATIVES AND PRO BOWLERS:
      We welcome Reps (and pros) associated with ANY ball company that had its equipment used on the telecasts to submit a list of the equipment and drilling information to
us. There is no cost to be included and again any company that supplies information on their equipment used during the shows will have their information published.



We're here to help!

At BowlingCommunity.com you can get FREE advice from bowling coaches and league bowlers who thrive on helping other bowlers!
Post questions about your game, your technique or find how to overcome difficult lane conditions. You can even post videos of yourself bowling for critique and constructive criticism.

BowlingCommunity.com Recent Posts
Where is every one?
by djp1080 - 7 minutes 34 seconds ago
Fall/Winter Leagues 2017-18 thread
by Richie V. - Yesterday at 10:47 PM
Competing against high rev, high speed players
by BowlerBill - Yesterday at 07:59 PM
Honor Scores Not Received By USBC
by Mkirchie - 01/10/18 02:34 PM
Dual Angle Layouts
by Dennis Michael - 01/10/18 10:26 AM
Roto-Grip Hyper Cell Fused Video Ball Review
by mmalsed - 01/08/18 11:41 AM
Dare Devil Danger Video Ball Review
by sk8shorty01 - 01/07/18 08:56 PM
Good advice from my brother!
by Dylan585 - 01/05/18 04:13 PM
Hammer Purple Pearl Urethane
by nord - 01/01/18 09:58 PM
"Knocking the Shine" off of my Pearl Ball
by 6_ball_man - 01/01/18 09:11 AM
Have a happy and safe Holiday
by goobee - 01/01/18 02:34 AM
Sick Unethetical Advertising
by goobee - 01/01/18 02:26 AM


About BowlingFans.com | Contact Us | Advertise With Us | Site Map
Use of this website constitutes acceptance of our Terms of Use and Privacy Policy. | Material Connection Disclosure

Copyright © 1998 - 2018 - usrbingeek LLC | Copyright Policy
BowlingFans.com, BowlingFans, The Right Approach, Kegler's Connection, Tour411, BallBeat, BowlingCommunity.com, BowlSearch.com, and Bowling News You Can Use are trademarks of usrbingeek LLC. All other trademarks and tradenames are property of their respective owners.